RRP5.9
SENSOR LOW PAPER (PL 5.1.4)
Removal
1)
Remove the EP CARTRIDGE and Paper Cassettes.
2)
Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
3)
Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
4)
Place the printer down on its right side.
Be careful not to scratch the cover, and do not drop the printer.
5)
Disconnect the connector (P/J260) of the HARNESS ASSEMBLY LOW 1 (PL 5.1) from the SEN-
SOR (Figure 1).
6)
Release the hooks of the SENSOR, and remove it from the GUIDE TRAY RIGHT (PL 5.1) (Figure
1).
Replacement
1)
Install the SENSOR LOW PAPER to the GUIDE TRAY RIGHT (PL 5.1), and secure it with hooks
(Figure 1).
2)
Connect the connector (P/J260) of the HARNESS ASSEMBLY LOW 1 (PL 5.1) to the SENSOR
(Figure 1).
3)
Return the printer to the normal use state.
4)
Install the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
5)
Install the COVER REAR 500 (PL 7.1) (RRP7.9).
6)
Install the EP CARTRIDGE and Paper Cassettes.
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure 1. Low Paper Sensor
1 - 90