Rrp12.9 550 Feeder Option (Pl12.2) - TallyGenicom 9045N Service Manual

RRP12.9 550 FEEDER OPTION (PL12.2)

Removal
1) Remove the 5 screws (gold tapping, 8mm) securing the COVER RE550 (PL 12.1.25) to the
frame.
2) Remove the COVER RE550.
3) Disconnect the connector (P/J855) of the HARNESS ASSY CLSNR1 (PL 12.1.31) from the
HARNESS ASSY CLSNR2 (PL 12.1.36).
4) Disconnect the connector (P/J820) of the MOTOR FEEDER (PL 12.1.17) from the HARNESS
ASSY FDR MOT (PL 12.1.37).
5) Disconnect the connector (P/J801) of the HARNESS ASSY SIZE FDR1 (PL 12.1) from the
HARNESS ASSY SIZE FDR2 (PL 12.1.35).
6) Release the clamp of the HARNESS ASSY FDR MOT and HARNESS ASSY SIZE FDR2 from
the clamps.
7) Remove the 6 screws (gold tapping, 8mm) securing the 550 FEEDER OPTION to the frame.
8) Remove the 550 FEEDER OPTION from the frame.
The following step is performed, if necessary.
9) Remove the 3 screws (silver, 6mm) securing the CHUTE 550 LOWER (PL 12.2.34) to the 550
FEEDER OPTION, and remove the CHUTE 550 LOWER from the 550 FEEDER OPTION.
Chapter 3 Removal and Replacement Procedures (RRPs)
1 - 224