List Of Test Equipment; Table 1 List Of Test Equipment - Agilent Technologies InfiniiVision 7000 Series Service Manual

List of Test Equipment

List of test equipment

Table 1
Equipment
Test connector, 8-by-2*
Digital Multimeter
Power Splitter
Oscilloscope Calibrator
Signal Generator
Power Meter & Sensor
BNC banana cable
BNC cable (qty 3)
Cable
Probe cable*
Adapter
Adapter
Adapter
Blocking capacitor and shorting cap
Adapter (qty 3)
7000 Series Oscilloscopes Service Guide
Below is a list of test equipment and accessories required to
perform the performance test verification procedures.
Critical Specifications
See page 26 for instructions on building test connector.
0.1 mV resolution, 0.005% accuracy
Outputs differ by 0.15 dB
DC offset voltage of -5.5 V to 35.5 V, 0.1 V resolution
25 MHz—500 MHz sine wave, 5 ppm
25 MHz, 100 MHz, 350 MHz, 500 MHz, and 1 GHz
sine waves
±
1 GHz 3% accuracy
BNC (m) to dual banana
BNC - BNC, 48" length
Type N (m) 609.6 mm (24 in.)
No substitute
BNC(f) to banana(m)
BNC Tee (m) (f) (f)
Type N (m) to BNC (m)
Note: if a BNC blocking capacitor is not available use an
SMA blocking capacitor.
N(m) to BNC(f)
Testing Performance
Recommended Model/
Part Number
n/a
Agilent 34401A
Agilent 11667B
Fluke 5820A
Agilent N5181A,
E4400B, or 8648A
Agilent E4418B & 8482A
Pomona 2BC-BNC-36 or
Agilent 11001-66001
†
Agilent 10503A
Agilent 11500B
†
Agilent 01650-61607 or
Agilent N6450-60001
†
Agilent 1251-2277
†
Agilent 1250-0781 or
Pomona 3285
Agilent 1250-0082 or
Pomona 3288 with
Pomona 3533
Agilent 10240-70001 +
Agilent 1250-0774 or
Agilent 11742A +
Pomona 4288 +
Pomona 5088A
Agilent 1250-0780
2
23