3
Preparing for Use
Equipment for Automated Test System
Ethernet
Figure 3-1 Typical Setup for Automated Test System (Ethernet Interface)
3-2
The following equipment are required to construct an
automated test system using the Ethernet interface:
• The Agilent N9360A Multi UE Tester.
• A system controller with the Ethernet interface.
• A 10Base-T/100Base-TX UTP cross-over cable to connect the
controller and the Tester or two 10Base-T/100Base-TX UTP
straight cables to connect a HUB, the controller and the
Tester.
• An RF cable to connect the RF signal from or to the mobile
phone under test, the Antenna Coupler (Agilent
N9360A-A02) to connect RF signal from or to the mobile
phone to couple RF signal from or to the mobile phone.
• A printer and an appropriate cable (if required).
A typical setup for an automated test system using the Ethernet
interface as shown in
N9360A Multi UE Tester CDMA2000 Programming Manual
Figure 3-1
below: