Class Of Service - Ext/Ext Restriction; Class Of Service - Extension Feature - Panasonic S-ICX Technical Manual

Section 700 - Operation
Table 4. Trunk COS
Number
1 Intercom Ringing Tone (trunk or intercom ring tone)
2 Dial Tone to Tie Lines (Enable/Disable)
3 Forced Recover on Fast-Busy Tone (Send fast busy or disconnect line)
4 DDI Dialled Number Conversion Table (DDI/CLI Table A or B)
5 Paging on DISA/Tie-Line Call (Allow/Restrict)
6 DISA Security Code Verification
7 Network Flash Forwarding
8 Network Flash Receive
9 Brokers Hold for Network Calls
10 Priority Message-Waiting Set/Cancel
11 Network-to-Network Transfer
12 Camp-On for Tie-Lines
Hardware Requirements
• N/A
Considerations
• N/A

Class of Service - Ext/Ext Restriction

Ext/Ext Restriction COS allows or restricts calls placed to other extensions based upon the Extension
COS. Each Extension COS is programmed to either originate or not originate calls to another
Extension COS.
Hardware Requirements
• N/A
Considerations
• N/A

Class of Service - Extension Feature

Extension COS allows or restricts access to certain extension features. (The extension features are
described later in this manual.) Each extension is assigned to one of 16 classes of service (00-15).
The following table shows the features that can be enabled/disabled for each Extension COS.
Table 5. Extension COS
Number
1 Intercom Call Type (Tone/Voice)
2 Onhook Transfer at Ringback (Allow/Restrict)
3 Onhook Transfer at Talk (Allow/Restrict)
S-ICX-50-700
Feature
Class of Service Features
Feature
S-ICX (International) issued October 2000
Chapter 3. System Features
29