Panasonic S-ICX Technical Manual page 148

Chapter 5. Key Telephone Features
6. For 3-party Conference Call Only:
To release a conference member, press PROG + 1 to
release conference member 1 or press PROG + 2 to release
conference member 2, etc.
Note: The conference member numbers are shown on the
display.
7. To drop out of the conference call, hang up.
To establish a two-party private conversation from a 3-party conference:
1. While on a call, press the CONF + 1 (2) to have a private
conversation with the CNF 1 (2) party as shown on the dis-
play.
2. To reestablish the conference, press CONF.
To remove a Busy Tone (Hang up) from an 8-party conference:
1. During an conference with more than 3 parties, press
CONF + (n) (where n is the number 1-7 for the conference
parties) to individually select a conference party.
2. If you did not select the conference party that is giving busy
tone, re-enter the conference by pressing the CONF key.
3. If you selected the conference party that is giving busy tone,
hang up and then go off-hook again and press the CONF
key to re-enter the conference call.
Hardware Requirements
• A Conference Card (VB-44120) must be installed in the System in order to conference more than
three parties.
Considerations
• **If all the internal parties hang up, the conference call will be disconnected. If the internal party
remains in the conversation, the conference call remains in progress.
• When three parties are conferenced, a built-in 3-party conference circuit is used. If no 3-party
conference circuit is available, a conference cannot be established.
148
Action
Action
Action
S-ICX (International) issued October 2000
Section 700 - Operation
Result
(Available up to 3-party conference. Not
available for 4-party or more conferenc-
ing)
(See ** Consideration below)
Result
You and the selected party are in a sepa-
rate conversation from the other confer-
ence parties.
CNF1:CO XXX or EXT XXX and
CNF2:CO YYY or EXT YYY displays
(where XXX = first party and YYY = sec-
ond party)
Result
The other party is placed on hold.
CONF Members: X (where X = 4-7
party conference) displays
CONF Members: Y (where Y = 4-6
party conference) displays
S-ICX-50-700