Energy Saver Function - Ricoh FW780 Service Manual

8.5 ENERGY SAVER FUNCTION

When the copier is not in use, the energy saver function reduces the power
consumption by decreasing the fusing temperature.
When the Clear Modes/Stand-by key is hold down for over 2 seconds, the copier
goes into the energy saver mode. A message is displayed on copy counter and
all the other indicators turn off.
The fusing temperature is decreased by 15 C from one of the normal mode
settings for copying. The energy saving ratio is approximately 14%. The waiting
time until the copier returns to the ready condition is approximately 60 seconds.
NOTE: The above energy saving ratio is a standard value measured in
laboratory tests under controlled conditions. The actual ratio will vary
depending on environmental conditions, copy modes, power supply
conditions and measurement instruments.
Press the Clear Mode/Standby key. The copier is returned to the ready condition
after a warm-up time.
When the auto energy saver mode (SP #10) is selected, the copier automatically
goes to the energy saver mode at the auto reset time selected by SP #9.
SM 2-34 A163