Ricoh FW780 Service Manual page 392

SERVICE TOOLS
Mode No.
Synchro-cut Length
Auto Adjustment
(297 mm)
-35
Synchro-cut Length
Auto Adjustment
(1,189 mm)
-36
-37 Not Used
Synchro-cut Length
Manual Adjustment
(297 mm)
-38
Synchro-cut Length
Manual Adjustment
(1,189 mm)
-39
-40 Not Used
to
-44
Roll Feeder
Registration
-45
Forced Ready
Condition
-50 (Factory Use)
Lamp Off Mode
-51
B047/B048
Function
Adjusts the original cut length in
Synchro Cut mode based on a 297
mm sheet (standard length). Insert the
297 mm length original five times (this
number displayed on the copy number
indicator can be changed : 1 to 10). If
the actual original length is different
from the standard length, input the
following value in the cut length
indicator before inserting the original:
Actual Length - Standard Length
Then the machine automatically
calculates the correct value, and the
value of SP#-38 is changed.
Adjusts the original cut length in
Synchro Cut mode at 1,189 mm.
Insert the 1,189 mm length original five
times (this number displayed on the
copy number indicator can be
changed: 1 to 10). If the actual original
length is different from the standard
length, input the following value in the
cut length indicator before inserting the
original:
Actual Length - Standard Length
Then the machine automatically
calculates the correction value. The
data is overwritten on SP#-39.
Adjusts the synchro cut length for a
297 mm original. Increasing the
number will shorten the paper cut
length.
Adjusts the synchro cut length for a
1,189 mm original. Increasing the
number will shorten the paper cut
length.
Adjusts the paper registration from the
roll feederS. When SP#-5 (Registration
Adjustment) is carried out, this data will
be automatically set with that data.
Forces the machine into the "Ready"
condition regardless of the fusing
temperature. This mode cannot be
used during the start-up development
agitation.
Fluorescent lamp does not turn on
during the copy cycle.
4-18
Data
–9.9 9.9
0
1 step = 0.1 mm
–50 50
0
1 step = 0.1 mm
–9.9 9.9
0
1 step = 0.1 mm
(This value is over written
when SP#-35 is
performed.)
–50.0 50
0
1 step = 0.1 mm
(This value is over written
when SP#-36 is
performed.)
0: Standard
–9.9 9.9
0
Delay Advance
0: Normal
1: Forced Ready
Condition
0: Normal
1: Lamp off
SM