6. INSTALLATION PROCEDURE
Roll Feeder (A571)
CAUTION: Unplug the copier power cord before starting the following
procedure.
Check the accessories and their quantities according to the following list:
Harness Cover ............................................................................ 2 pcs
Angle Bracket .............................................................................. 1 pc
Spacer ......................................................................................... 1 pc
Small Cap..................................................................................... 1 pc
Screws - M4x8 ............................................................................ 8 pcs
Screws with Spring Washer - M4x8 ............................................. 2 pcs
NOTE: When the Roll Feeder is installed on the copier, the table (A714) is
required.
A163
7-10
SM