7.6 ROLL FEED PAPER SKEW ADJUSTMENT
[B]
[C]
1. Mark a line [A] on the exposure glass [B].
2. Make 594 x 1189 mm copies from the roll feeder unit.
NOTE: 594 mm wide paper is easier to adjust than 841 mm wide paper.
3. Measure the lengths [C] and [D].
4. Loosen the 2 screws [E] which determine the paper spool height.
5. If C > D, lower the right side of the paper spool. If C < D, do the opposite.
6. Make another copy. Check the lengths [C] and [D].
7. Repeat steps 4 to 6 if necessary.
NOTE: If the 10 or more copies are made continuously, the nip band width
of the fusing unit may change. For correct adjustment, do this
procedure at least 10 minutes after a continuous copy run of 10 or
more.
A163
[A]
[E]
[D]
7-22
[E]
SM