4.3.2 INPUT/OUTPUT CHECK MODE
Input Check Mode Table
The on/off status of the selected electrical component is displayed in the paper
length indicator ("ON" or "OFF" is displayed). If a program number not used is
selected, "NOT" is displayed.
Program No.
-1
Registration Sensor
-2
Exit Sensor
-3
Original Registration Sensor
-4
Entrance Sensor
Main Motor LOC Signal
-5
(Status is "ON" when the main motor is normally rotating.)
Door Switch
-6
(Status is "ON" when the door is open.)
-7
Original Entrance Sensor (A252 copier only)
-8
Original Rear Sensor (A252 copier only)
-9
Not Used
-10
R/F Leading Edge Sensor
-11
Roll Feeder Door Switch
-12
Right Cutter Switch
-13
Left Cutter Switch
-14
Paper End Sensor
Exit Cover Open
-16
(Status is "ON" when the door is open.)
SM
Sensor/Switch/Signal
4-9
SERVICE TOOLS
A251/A252