Fusing; Fusing Unit Removal - Ricoh FW780 Service Manual

5.5 FUSING

5.5.1 FUSING UNIT REMOVAL

[G]
[C]
[B]
NOTE: Close the paper path section to remove and reinstall the fusing unit.
1. Remove the copier rear cover.
2. Open the exit cover [A] and remove the shoulder screws [B] at both ends.
Remove the screws [C] for the grounding wires.
3. Disconnect the connector [D], remove the screw [E], and flex the hinge arms [F]
of the exit cover slightly to the outside of the exit unit shafts and remove.
4. Turn the exit unit [G] 1/4 of a turn to the front side (rear view) and remove it by
pulling out.
NOTE: When reinstalling the exit unit, set the right hinge [H] between the two
pulleys [I] and raise the left hinge [J] using tape [K].
SM
[J]
[A]
5-7
[K]
[H]
[C]
[B]
A252R509.WMF
FUSING
[I]
[D]
[F]
[E]
A251/A252