Enable CCM
Step
Task
1
Enable CCM.
2
Configure the transmit interval (mandatory).
The interval specified applies to all MEPs in
the domain.
Enable Cross-checking
Task
Enable cross-checking.
Start the cross-check operation for an MEP.
Configure the amount of time the system waits for a
remote MEP to come up before the cross-check operation
is started.
Loopback Message and Response
Loopback Message and Response (LBM, LBR), also called Layer 2 Ping, is an administrative echo
transmitted by MEPs to verify reachability to another MEP or MIP within the maintenance domain. LBM
and LBR are unicast frames.
Task
Send a Loopback message.
Linktrace Message and Response
Linktrace Message and Response (LTM, LTR), also called Layer 2 Traceroute, is an administratively sent
multicast frames transmitted by MEPs to track, hop-by-hop, the path to another MEP or MIP within the
maintenance domain. All MEPs and MIPs in the same domain respond to an LTM with a unicast LTR.
Intermediate MIPs forward the LTM toward the target MEP.
88
|
802.1ag
Command Syntax
no ccm disable
Default: Disabled
ccm transmit-interval seconds
Default: 10 seconds
Command Syntax
mep cross-check enable
Default: Disabled
mep cross-check mep-id
mep cross-check start-delay
number
Command Syntax
ping ethernet domain name ma-name ma-name remote
mac-addr mac-address
{
|
mep-id
}
interface
source
port
}
{
|
mep-id
Command Mode
ECFM DOMAIN
ECFM DOMAIN
Command Mode
ETHERNET CFM
ETHERNET CFM
ETHERNET CFM
Command Mode
EXEC Privilege