Figure 3-11. Creating and Displaying SNMP Access Levels
For details on SNMP, see
Setting the Enable Password
To change the Privileged Exec password (also called the "Enable" password) in SFTOS Version 2.3.1 and
above, you do so in Global Config mode. Enter
Figure 3-12. Setting the Enable Password
Force10 #enable passwd
Enter new password:*******
Confirm new password:*******
Password Changed!
Enabling Interfaces
This section covers the enabling of ports, VLANs, and management interfaces (Telnet, SNMP):
•
Enabling Ports on page 38
•
Setting the Management IP Address on page 39
•
Enabling Telnet to the Switch on page 39
•
Configuring an Interface with an IP Address on page 40
•
Using the Show IP Interface Command on page 40
•
Setting up SNMP Management on page 41
Enabling Ports
When the switch is first installed, all ports are disabled. To enable all ports in Layer 2, enter
in Global Config mode (see
all
Interface Config mode (for the selected interface — see
Figure 3-13. Enabling Ports Globally
Force10 >enable
Force10 #config
Force10 (Config)#no shutdown all
Force10 (Config)#
38
|
Getting Started
Setting up SNMP Management on page
enable passwd
Figure
3-13). Alternatively, you can use the
71.
, press Enter, and enter a new password:
no shutdown
Figure
3-14).
no shutdown
command in