Adjust The Oampdu Transmission Parameters; Link Performance Event Monitoring; Enable Error Monitoring - Dell Force10 C150 Configuration Manual

Adjust the OAMPDU Transmission Parameters

Task
Specify a the maximum or minimum
number of OAMPDUs to be sent per
second.
Set the transmission mode to active or
passive.
Specify the amount of time that the
system waits to receive an OAMPDU
from a peer before considering it
non-operational.

Link Performance Event Monitoring

Link Performance Event Monitoring OAM monitors the receive side of a link for a set of pre-defined
errors and executes an action when a threshold is exceeded; it is enabled by default. Both peers on the link
must be have link performance event monitoring enabled for discovery to complete.
There is a high and low threshold for each pre-defined error; an event occurs when any threshold is
exceeded. FTOS periodically polls hardware registers for the current frame and symbol error count. If an
interface exceeds a threshold, a notification is sent to the peer and the interface is placed in error-disabled
state.
• Enable Error Monitoring on page 99
• Execute an Action upon Exceeding the High Threshold on page 102

Enable Error Monitoring

The polling interval for Link Performance Monitoring is 100 milliseconds.
Task
Start (or stop) Link Performance
Monitoring on an interface.
Enable (or disable) support for Link
Performance Monitoring on an interface.
Command Syntax
ethernet oam max-rate value
[
Range: 1-10
Default: 10
ethernet oam mode active
{
Default: Active
ethernet oam timeout value
Range: 2-30 seconds
Default: 5 seconds
Command Syntax
ethernet oam link-monitor on
no ethernet oam link-monitor on
Default: Enabled
ethernet oam link-monitor supported
no ethernet oam link-monitor supported
Default: Enabled
min-rate value
| ]
passive
| }
Command Mode
INTERFACE
INTERFACE
INTERFACE
Command Mode
INTERFACE
INTERFACE
802.3ah | 99