The Do Command; Undoing Commands - Dell Force10 C150 Configuration Manual

The do Command

Enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE,
SPANNING TREE, etc.) without returning to EXEC mode by preceding the EXEC mode command with
the command
Note: The following commands cannot be modified by the
configure
Figure 2-4. Using the
FTOS(conf)#do show linecard all
-- Line cards
Slot Status
---------------------------------------------------------------------------
0 not present
1 not present
2 online
3 not present
4 not present
5 online

Undoing Commands

When you enter a command, the command line is added to the running configuration file. Disable a
command and remove it from the running-config by entering the original command preceded by the
command
ip-address
Note: Use the
"no" form of a command.
Figure 2-5. Undoing a command with the
FTOS(conf)#interface gigabitethernet 4/17
FTOS(conf-if-gi-4/17)#ip address 192.168.10.1/24
FTOS(conf-if-gi-4/17)#show config
!
interface GigabitEthernet 4/17
ip address 192.168.10.1/24
no shutdown
FTOS(conf-if-gi-4/17)#no ip address
FTOS(conf-if-gi-4/17)#show config
!
interface GigabitEthernet 4/17
Layer 2 protocols are disabled by default. Enable them using the
PROTOCOL SPANNING TREE mode, enter
40 | Configuration Fundamentals
do
. Figure 2-4 illustrates the
.
Command
do
--
NxtBoot
online
online
no
. For example, to delete an ip address configured on an interface, use the
command, as shown in Figure
or command as discussed in
help ?
IP address removed
do
command.
"do" form of show command
ReqTyp CurTyp Version
E48TB E48TB 1-1-463
E48VB E48VB 1-1-463
2-5.
Obtaining Help
Command
no
IP address assigned
"no" form of IP address command
no disable
to enable Spanning Tree.
command:
do enable, disable, exit
Ports
48
48
command to help you construct the
no disable
command. For example, in
, and
no ip address