• WPS-PIN
NOTE:
•
WPS-PIN is a method to authenticate and register devices required for wireless configuration, by entering PIN
code to a printer and computer. This setting, performed through access point, is available only when the
access points of your wireless router supports WPS.
•
Before WPS-PIN starts, you will need to enter your PIN code at the web page of the wireless access point.
See the access point manual for the details.
1
On the operator panel, press the
2
Select Admin Menu, and then press the
3
Select Network, and then press the
4
Select Wireless Setup, and then press the
5
Select WPS, and then press the
6
Select PIN Code, and then press the
7
Take a note of PIN code displayed on the operator panel.
8
Select Start Configuration, and then press the
9
If SSID selection screen appears, select the SSID, and then press the
10
Enter the PIN code of the printer at the web page of the wireless access point.
11
Wait a few minutes until the printer restarts to establish the wireless network.
12
Print a System Settings page from the operator panel.
See
"Printing a System Settings Page" on page
13
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
•
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
(System) button.
button.
button.
button.
button.
button.
182.
Printer Connection and Software Installation
button.
button.
132