Setting The Ip Address - Xerox DocuPrint C2428 User Manual

1.3

Setting the IP Address

This section describes the procedures to set the IP address.
You can set the IP address with one of the following methods.
● Using the Quick Setup menu on the control panel.
Setting the IP address from the control panel.
●
● Using the IP Setup Tool contained on the Software Pack CD-ROM supplied with this
printer.
This section describes the procedure to set the IP address from the control panel.
To set the IP address using the IP Address Setting Tool, refer to the Software Pack
Operation Guide (manual.pdf).
To set the IP address using the Quick Setup menu, refer to "1.2 Setting the Printer
Environment With the Quick Setup Menu" (P.30).
You can change the IP address from the CentreWare Internet Services. For information about CentreWare
●
Internet Services, refer to "1.4 Configuring from the Computer (CentreWare Internet Services)" (P.39).
Depending on the network environment, you may need to set the subnet mask and gateway address for the printer.
●
If your network has the DHCP, BOOTP, or RARP environment, this printer can obtain these addresses from each
of these servers.
By factory default setting, these addresses are automatically obtained from the DHCP server.
●
Use the DHCP server together with the Windows Internet Name Service (WINS) server.
●
When using the BOOTP or RARP server, change the item [Get IP Address] to [BOOTP] or [RARP] on the
●
control panel. Check with your system administrator for any queries on the BOOTP or RARP environment.
"Chapter 5 Setting Control Panel" (P.121)
1
33