Xerox DocuPrint C2428 User Manual page 178

6.3 Unusual Conditions
Symptom
Cannot print.
6
178
Cause
Is the <Standby> indicator off?
Is there a message displayed on the
control panel display?
Is your computer set up for bi-
directional communication
(connection with a parallel interface
cable)?
Is the memory capacity insufficient?
Action
This printer is in an off-line state or in a
menu setting mode. Take actions
depending on the indications below.
[Off-line]
●
Press the <Off-line> button to exit
the off-line state.
● Others
Press the <Menu> button to exit the
menu setting mode.
"2.1.2 Control Panel" (P.50)
Take actions according to the
message.
"6.5 List of Messages" (P.186)
By default, bi-directional
communication is set to [Enable]. You
cannot print unless your computer is
set up for bi-directional
communication. If that is the case, set
bi-directional communication to
[Disable] and then start printing.
"Parallel" (P.137)
Try to print again in the following way.
When [Print Mode] is set to [High
●
Resolution], set it to [High Quality]. If
the status is still not improved, set it
to [Standard].
● Use [Print Page Mode].
● Increase the print page buffer
capacity.
Or install Additional memory (optional)
to increase memory.
For information about [Print Mode], refer
to the On-line Help for the printer driver.