Xerox DocuPrint C2428 User Manual page 141

SMB
Set when using SMB.
■Port Status
Set the status of the SMB port to enabled or disabled when the power is switched on. Default is
[Enable], to use SMB.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the unused port status to [Disable] or change the memory allocation capacity, in case of
insufficient memory.
■Transpt Protocol
Set the protocol of the transport layers of the SMB. You can use either NetBEUI or TCP/IP or both
of them. Default is [TCP/IP, NetBEUI].
IP Address is needed on both the computer and the printer to use TCP/IP.
*1 (P.155)
■Print Mode
Set the process method (targeted print language) of the print data.
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [HP-GL/2] [PCL] [TIFF]
Each piece of data received from the computer is processed. [PS] is indicated when the PostScript
Software Kit is installed.
*2 (P.155)
■PJL
You can use the PJL command with this printer, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the printer driver. Set the status
of the PJL command sent from the computer to enabled or disabled. By using the PJL command, you
can select the print language for the next data, even if the machine is under another process in any
print language. Set [Enable] for normal use. Default is [Enable].
■TBCP Filter
Set the TBCP filter to enabled or disabled, while data from the PostScript is processed. This item is
available when PostScript Software Kit (optional) is installed. Default is [Disable].
5.2 Description of Common Menu
5
141