Xerox DocuPrint C2428 User Manual page 142

5.2 Description of Common Menu
IPP
Set when using IPP.
■Port Status
Set the status of IPP port to enabled or disabled when switching of the power. Default is [Disable].
Set to [Enable] when you use IPP.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the status of the unused port to [Disable], or change the memory allocation capacity, in case of
insufficient memory.
To activate the IPP port, you will need to set the IP address.
■Print Mode
Set the process method (targeted print language) of the print data.
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [HP-GL/2] [PCL] [TIFF]
Each piece of data received from the computer is processed. [PS] is indicated when the PostScript
Software Kit is installed.
*2 (P.155)
■PJL
With this printer you can use the PJL command, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the printer driver. Set the status
5
of the PJL command sent from the computer to enabled or disabled. By using the PJL command, you
can select the print language for the next data, even if the machine is under another process in any
print language. Set [Enable] for normal use. Default is [Enable].
■Access Control
Set the access control to enabled or disabled when canceling, deleting, or pausing a print job. Default
is [Disable].
■DNS
Set whether to use the name re-signed in the Domain Name System (DNS) as the printer is
recognized. Default is [Enable], which is used as the DNS name. When [Disable] is set, recognition
is processed under the IP Address.
■Add Port No.
Set the additional port number 0, 80, or select from 8000 to 9999. Default is [80].
■Connect Time-Out
While receiving print data, set the time from when the data is interrupted to when the connection is
cut, in the range of 0 to 65535 seconds, incremented by 1 second. Default is [60Secs].
■TBCP Filter
Set the TBCP filter to enabled or disabled, while data from the PostScript is processed. This item is
available when PostScript Software Kit (optional) is installed. Default is [Disable].
142
*1 (P.155)
*3 (P.155)