Dynamic Methods Of Setting The Printer's Ip Address - Xerox Phaser 6280 User Manual

Dynamic Methods of Setting the Printer's IP Address

There are two protocols available for dynamically setting the printer's IP address:
•
•
You can turn on/off both protocols using the control panel, or use CentreWare IS to turn
on/off DHCP.
Note:
Then select Information Pgs and press the OK button. Finally, select Configuration , and
then press the OK button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1. On the control panel, select the Menu button.
2. Select the Admin menu, and then press the
3. Select the Network Setup menu, and then press the
4. Select the TCP/IP menu, and then press the
5. Select IPv4 , and then press the
6. Select Get IP Address , and then press the OK button.
7. Select DHCP , and then press the OK button.
Using CentreWare IS
To turn on/off the DHCP protocol:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Select Properties .
4. Select the Protocols folder on the left navigation panel.
5. Select TCP/IP .
6. In the Get IP Address field, select the DHCP/Autonet option.
7. Click the Save Changes button.
Downloaded From ManualsPrinter.com Manuals
DHCP (enabled by default on all Phaser printers)
AutoIP
You can view the printer's IP address at any time. On the control panel, select Menu .
Configuring the Network Address
button.
OK
OK
button.
OK
button.
OK
Phaser® 6280 Printer
36
button.