Installing And Connecting; Package Contents - NETGEAR RT210 Reference Manual

This chapter provides instructions on installing the Model RT210 or Model RT211 router and
connecting to the built-in interface through a serial or Telnet connection.
If you are a PC user, you can configure the router either by an easy-to-use software program, the
FirstGear ISDN router configuration utility, or the built-in interface. For complete instructions on
using FirstGear, refer to Getting Started Using FirstGear.
If you are using a Macintosh or UNIX-based workstation, you can configure the router only by
using the built-in interface. However, you can connect a PC to your router and use FirstGear for
the configuration process. After configuration is complete, connect the router back to your
Macintosh for normal operation. For complete instructions on using FirstGear, refer to Getting
Started Using FirstGear.
For further information on the different methods for configuring your router, refer to
"Configuration Methods" in

Package Contents

The product package should contain the following items:
• NETGEAR Model RT210 or Model RT211 ISDN router
• AC Power Adapter 9V-DC output
• Two 10 foot 10BASE-T Ethernet cables (round)
• 10 foot ISDN cable (flat)
• 9-pin D-connector to RJ-45 cable adapter

Installing and Connecting

Installing and Connecting
Chapter 3, "Configuring the Router."
Chapter 2
2-1