Using The Built-In Interface Basic Setup - NETGEAR RT210 Reference Manual

Using the Built-In Interface Basic Setup

This section shows you how to:
• Name the router
• Enter the network address
• If in North America, configure the ISDN line
• Connect to another NETGEAR or Bay Nautica Series router
• Connect to a router using PPP
• Verify autocall operation
• Configure a PPP path
To configure your router through the Built-in Interface Basic Setup instead of the Built-in Interface
Quick Setup, follow these steps:
Establish a Serial or Telnet connection as described in
1.
Port or a Telnet
Press any key to display the screen that prompts for a password.
2.
Enter PASSWORD in uppercase within the brackets on the screen.
3.
PASSWORD is the password shipped with the router.
If you have connected to this interface before and assigned a different password, enter the
password exactly as you previously typed it. To clear any previous configurations and restore
the default condition, follow these steps:
Enter DEFCON.
a.
Enter Y when you are asked whether you are sure you want to erase CONFIG and
b.
reboot.
The unit erases any saved configuration, load the defaults, and reboot.
Press [Enter] after the rebooting procedure runs for about 10 seconds.
c.
Enter PASSWORD.
d.
Enter N when you are asked whether you want to run Quick Setup.
4.
Configuring the Router
Reference Guide for the Model RT210/RT211 ISDN Routers
Connection" on page
"Connecting Through a Serial
2-12.
3-7