Using The Update System Parameters Form - NETGEAR RT210 Reference Manual

• IP
This command lets you configure the IP routing table.
• PPP
This command lets you configure the operating mode of the custom point-to-point protocol
connection.

Using the Update System Parameters Form

The Update System Parameters Form provides a list of router parameters that let you name the
router, change your password, and display the amount of time since the router was last rebooted.
Following are the menu command options and functions provided by the Update System
Parameters Form:
• Name
This is an alphanumeric name given to the router. Because this name is used during
authentication or login with a remote router, the name should be different from any other
routers that you are likely to connect together.
Spaces cannot be used as characters.
Default: NoConfig
• Old Password
When changing the password, you must first enter the current password. The current password
is not printed when typed. An indication that the password is invalid will be given only when
the form is submitted.
Default: PASSWORD
• New Password and Retype Password
The new password is entered and re-entered (for confirmation). The new password takes effect
immediately. This password is for access to the configuration manager and is not used in call
authentication.
• Time Since Reboot
This is the time in hours:minutes:seconds since the unit was last rebooted.
Menus and Commands
Reference Guide for the Model RT210/RT211 ISDN Routers
4-5