Advertisement
•
MinBandwidth (bps)
The minimum bandwidth that should be allocated to this path. A value of 0 initially uses
the single channel capacity. Other values may cause the unit to make additional switched
calls until the requirement is met for this path. It is advisable to use multiples of 64,000
bps for ISDN connections.
Default: 0
•
MaxBandwidth (bps)
The maximum bandwidth that can be used by this path. A value of 0 defines no upper
limit. A value of 64,000 prevents the use of both channels for this path.
Default: 0
•
DemandThreshold (%)
The percentage utilization of the path at which an additional call should be made. The
DEMAND THRESHOLD is disabled if given a value of 0.
•
ThresholdPd (sec)
This is the time-out period after which an idle switched call is automatically disconnected.
Default: 10
•
IdleThreshold(%)
The percentage utilization below which a switched call is determined to be idle.
Default: 0
•
Bandwidth Mode
Permanent or OnDemand
Default: OnDemand
•
AllowRIP
Enables IP RIP (Routing Information Protocol) in RIP1, RIP1 Compatibility, or RIP2
mode. Disables RIP if set to NONE. RIP1 Compatibility mode is a subset of RIP2 that
also supports and advertises networks with variable-length netmasks.
Default: None
Menus and Commands
Reference Guide for the Model RT210/RT211 ISDN Routers
4-9
Advertisement
Troubleshooting
