Using The Built-In Interface Quick Setup - NETGEAR RT210 Reference Manual

Reference Guide for the Model RT210/RT211 ISDN Routers

Using the Built-in Interface Quick Setup

When using the built-in interface Quick Setup, you are prompted to:
• Name your router with your account login name
• Enter your IP address
• Configure your ISDN line
In North America, you need to know your SPID(s), directory number(s), and the type of
switch that your telephone company has.
• Enter your account password
To connect to the built-in interface Quick Setup, follow these steps:
Establish a Serial or Telnet connection as described in
1.
Port or a Telnet
Press any key to bring up a screen that prompts for a password.
2.
Enter
3. PASSWORD
PASSWORD must be typed within the brackets on the screen. The router is shipped with this
password. You must enter the password in all uppercase letters in order to proceed.
Enter Y when you are asked if you wish to run Quick Setup.
4.
You are prompted to run Quick Setup only if you have not previously configured the router or
if a previous configuration has been cleared.
Follow these steps if you are not prompted, but want to run the Quick Setup program:
5.
Caution: By doing the following, you erase any previously saved configuration.
Enter DEFCON.
a.
Enter Y when you are asked if you wish to erase CONFIG and reboot.
b.
Press [Enter] after the rebooting procedure runs for about 10 seconds.
c.
3-4
Connection." on page
.
"Connecting Through a Serial
2-12.
Configuring the Router