Advertisement
Reference Guide for the Model RT210/RT211 ISDN Routers
•
IPAddr&Mask
Allows entry of the IP address and number of subnet mask bits for this interface. If a
subnet mask is not specified, the unit adds the default mask for the class of address
configured. This address should be part of the inter-router network addressing scheme.
Default: 1.1.1.1/8
If you type ADD in the Configure Paths Menu or type EDIT when any path except the LAN
Path is highlighted, the Update Path Form for an ISDN path is displayed.
The menu command options and functions that are displayed enable you to set up a PP path
are:
Note: If PAP or CHAP security is to be used, the path must be configured before a PPP
connection is attempted or the password/secret cannot be matched with that of the calling
device.
•
Name
This is a user-defined name. If calls are to be received from this path and PAP or CHAP
security is enabled, this name must be configured to that of the remote device name. If
PAP or CHAP security is not used on this path, the path can be automatically created on
detection of the start of the PPP. It is given the name of the port over which PPP is
established.
Default: None
•
Type
This field is for information only. The value is PPPRouter.
•
ISDN1/2/3/4
The ISDN number(s) to dial to connect to the remote unit. If calls are to be received from
this path and CLI is enabled, these numbers are compared with the calling number to
determine whether the call is accepted.
Default: No default
4-8
Menus and Commands
Advertisement
Troubleshooting
