Connecting Additional Wireless Client Devices After Wps Setup; Adding More Wps Clients - NETGEAR MBRN3000 User Manual

5. From the router Add WPS Client screen, enter the client PIN number, and then click Next.
• The router tries to communicate with the client for 4 minutes.
• The router WPS screen displays a message confirming that the client was added to the
wireless network. The router generates an SSID, and implements WPA/WPA2 wireless
security.
6. Note the new SSID and WPA/WPA2 password for the wireless network. You can view these
settings in the Wireless Settings screen. See
on page 2-4
To access the Internet from any computer connected to your router, launch a browser such as
Microsoft Internet Explorer or Mozilla Firefox. You should see the router's Internet LED blink,
indicating communication to the ISP.
Note: If no WPS-capable client devices are located during the 2-minute timeframe, the
SSID will not be changed and no security will be implemented on the router.
Connecting Additional Wireless Client Devices After WPS
Setup
You can add more WPS clients to your wireless network, or you can add a combination of WPS-
enabled clients and clients without WPS.

Adding More WPS Clients

Note: Your wireless settings remain the same when you add another WPS-enabled client,
as long as the Keep Existing Wireless Settings checkbox is selected in the
Advanced Wireless screen (listed under the Advanced heading in the router main
menu). If you clear this checkbox, when you add the client, a new SSID and
passphrase will be generated, and all existing connected wireless clients will be
disassociated and disconnected from the router.
To add a wireless client device that is WPS-enabled:
1. Follow the procedures in
PIN Entry to Add a WPS Client" on page
Wireless Network Configuration
Mobile Broadband Wireless-N Router MBRN3000 User Manual
"Manually Configuring Your Wireless Settings"
"Using a WPS Button to Add a WPS Client" on page 2-9
2-11.
v1.0, October 2009
or "Using
2-12