Table 3-3. Control Character Commands - NETGEAR RT210 Reference Manual

Table 3-3. Control character commands
Control
Action in the menu
Character(s)
[Cntl]+
A Same as in the form.
[Cntl]+
B Move to the previous page.
[Cntl]+
C None
[Cntl]+
E None
[Cntl]+
G Go to the top-level menu of the
path you are in.
[Cntl]+
H None
[Cntl]+
I None
[Cntl]+
L Go to the previous screen.
[Cntl]+
M Typed command line text submitted
for processing.
[Cntl]+
N Move to the next page in a multipage
form.
[Cntl]+
R Recall the last command entered.The
previous 10 commands are stored in a
circular buffer.
[Cntl]+
U Delete the command line text.
[Cntl]+
V Same as form.
[Cntl]+
Z Recall commands in reverse order.
Configuring the Router
Reference Guide for the Model RT210/RT211 ISDN Routers
Action in the form
Toggles VT100/Televideo Terminal Mode.
None.
Abort the form. You leave the form and go
to the previous menu without saving any
changes.
Submit the form. The changed parameters
are stored in current configuration memory.
Most changes take place immediately.
Go to the top level menu without saving any
field changes.
Backspace in the field, deleting characters.
Same as pressing the TAB key.
Leave the form and go to the previous
menu without saving any changes.
Move the cursor to the next field.
None.
Recall the last value stored in the field
where the cursor is located. Values are
recalled until the form is submitted by
(<CTRL>+E), after which the new value is
recalled.
Delete the field value.
Repaint the screen. Enables the screen to
be refreshed if the terminal is used for
hot-keying between this and other systems.
None.
3-3