Using The Update Path Form - NETGEAR RT210 Reference Manual

• CALL
Highlight the required path and type CALL or type CALL [path name] to establish the path.
You can also make switched circuit calls by typing CALL [circuit/telephone number] from
anywhere except this menu.
• CANCEL
Optionally highlight the required path and type CANCEL or type CANCEL [path name] to
cancel an established path.

Using the Update Path Form

The Update Path enables you to add, view, and change the configured paths, assign and enter
protocol addresses, and gain additional bandwidth.
The Update Path consists of two forms, both called the Update Path Form, but consisting of two
different sets of menu commands, depending on whether you want to edit or add a LAN or an
ISDN path.
If you type EDIT when the LAN Path is highlighted in the Configure Paths Menu, the Update Path
Form for a LAN path is displayed.
The Update Path form for a LAN path gives you the following menu command options and
functions:
• Name
Default: LAN01
Display item only. This is a system-assigned name.
• MAC Address
Display item only. This is the Ethernet MAC address for this interface.
• AllowRIP
Enables IP RIP (Routing Information Protocol) in RIP1, RIP1 Compatibility, or RIP2
mode. Disables RIP if set to NONE. The RIP1 Compatibility mode is a subset of RIP2 that
also supports and advertises networks with variable-length netmasks.
Default: None
Menus and Commands
Reference Guide for the Model RT210/RT211 ISDN Routers
4-7