Return Channels 1/2 - Yamaha AW4416 Operation Manual

Return channels 1/2

These are stereo input channels used mainly to input the return signals from inter-
nal effects 1/2. However they can also be used as supplementary input channels
by changing the input signal assignments of the input patch section.
The structure of these channels is identical to that of the input channels, with the
exception of the following differences:
1 Stereo
B No dynamics processor
C No direct output
D No AUX 7 send level from return channel 1
E No AUX 8 send level from return channel 2
Tip!
Since return channels 1/2 are stereo, selecting MIC/LINE INPUT or OPTION IN as
input signals will cause two adjacent odd-numbered/even-numbered signals to be
assigned. Also if DIGITAL STEREO IN is selected, the signals of both L/R will be
assigned.
• The reason that return channel 1 (2) has no send level to AUX 7 (8) is to pre-
vent the feedback loop that would occur if the signal returned from internal
effect 1 (2) were sent back to the same internal effect.
• Be aware that the AUX 7 (8) send level is not available even if a different input
signal is assigned to return channel 1 (2).
RETURN 1(...2)
METER
INSERT
ATT 4 BAND EQ
METER
METER
(EQ)
INSERT
ATT
4 BAND EQ
METER
(EQ)
Stereo in X 2
Chapter1—Welcome to the world of the AW4416
METER METER
PAN
INPUT
DELAY
METER METER
ON LEVEL
PAN
INPUT
DELAY
PRE/POST
RETURN1 can not be assigned to AUX7
(EFF1)
RETURN2 can not be assigned to AUX8
(EFF2)
PREFADER LISTEN/
AFTER PAN
SOLO
SOLO
ON AUX
— Operation Guide
...
25