Yamaha AW4416 Operation Manual page 215

Chapter12—Sampling pads
Tip!
• If you set the counter to measure units, you can set the FR. START, FR. END,
• Instead of using the [DATA/JOG] dial to vary a location continuously, you can
3. Move the cursor to the parameter whose setting you wish to change,
and press the [ENTER] key.
The cursor will move to the parameter setting, and the value of the selected
parameter will be displayed.
4. Use the [DATA/JOG] dial to set the parameter, and press the [ENTER]
key.
The setting will change, and the cursor will return to the parameter location of
step 3.
5. Repeat steps 3–4 to set the remaining parameters.
6. Move the cursor to the EXECUTE button and press the [ENTER] key.
A popup window will appear, asking you to confirm the Copy command.
7. To execute the Copy, move the cursor to the OK button and press the
[ENTER] key.
Tip!
You can undo the result of the copy by pressing the [UNDO] key immediately after
executing Copy.
200
— Operation Guide
and TO START parameters in measure/beat units.
use the keys of the locate section to move instantly to a desired locate point or
marker.