Yamaha AW4416 Operation Manual page 152

2. Move the cursor to the output jack whose patching you wish to change,
and use the [DATA/JOG] dial to select the signal that you wish to assign.
The following types of signal can be assigned to each output jack.
OMNI OUT jacks 1–4
Display
AUX 1 – AUX 8
RDR 1 – RDR16
ST L/ST R
BUS 1 – BUS 8
DIR 1 – DIR16
DIGITAL STEREO OUT jack
STEREO OUT jacks
Display
ST L/R
BUS 1/2 – BUS 7/8
DIR 1/2 – DIR15/16
AUX 1/2 – AUX 7/8
RDR 1/2 – RDR15/16
Digital I/O card (slot 1) OUTPUT 1–8
Digital I/O card (slot 2) OUTPUT 1–8
Display
BUS 1 – BUS 8
DIR 1 – DIR16
AUX 1 – AUX 8
RDR 1 – RDR16
ST L/ST R
Tip!
When selecting a signal for assignment to an output jack, selections beginning with
"I-" such as "I-I8" or "I-M16" may be displayed in gray. Selections beginning with
"I-" indicate insert-out points of each channel. The gray display indicates that this
insert point is invalid. (For details on insert I/O patching, refer to page 140.)
Type of signal
AUX buses 1–8
Recorder direct out 1–16
L/R channels of the stereo output channel
Buses 1–8
Input channel direct out 1–16
Type of signal
Stereo output channel
Buses 1/2–7/8
Input channel direct out 1/2–15/16
AUX buses 1/2–7/8
Recorder direct out 1/2–15/16
Type of signal
Buses 1–8
Input channel direct out 1–16
AUX buses 1–8
Recorder direct out 1–16
L/R channels of the stereo output channel
Chapter8—Patching
137
— Operation Guide