Using Aux Send/Return To Apply An Effect; Patching - Yamaha AW4416 Operation Manual

Chapter10—Internal effects
Using AUX send/return to apply an
effect
As an example of using an effect with AUX send/return, here's how to apply effect
1 via AUX bus 7.

Patching

Make sure that the AUX send/return patching for effect 1 is appropriate.
1. Press the [SETUP] key
The SETUP screen Patch IN page will appear.
If the Patch IN tab is not assigned to the [F1] key, press the [SHIFT] key + [F1] key
to switch the tab, and then press the [F1] key.
2. Make sure that the EFFECT PATCH parameter EFF1 is set to "AUX 7."
The EFFECT PATCH parameters select whether effects 1/2 will be used via AUX or
inserted into a specific channel. By default, EFF1 (effect 1) is assigned to AUX 7
and EFF2 (effect 2) is assigned to AUX 8, as shown above.
Tip!
If EFF1 is set to "INSERT, " move the cursor to the "INSERT" field and use the [DATA/
JOG] dial to change it to "AUX 7. " Then move the cursor to the OK button and press
the [ENTER] key.
3. Make sure that the MIXER CHANNEL INPUT ASSIGN parameter RTN1 is
set to "EFF1 L/R."
The MIXER CHANNEL INPUT ASSIGN area switches the signal that is assigned to
the input channel/return channel of the mixer. By default, "EFF1 L/R" (L/R output
of effect 1) is assigned to RTN1 (return channel 1).
Tip!
If RTN1 has been changed to another setting, move the cursor to the setting area,
and rotate the [DATA/JOG] dial to change the setting to "EFF 1 L/R. "
166
— Operation Guide
[F1] (Patch IN) key.