Replacing A Pci Card; Removing And Replacing An Internal Hard Disk Drive; Figure 7-33 Installing A Pci Card - HP Integrity rx1600 Operation And Maintenance Manual

Removing and Replacing Components

Removing and Replacing an Internal Hard Disk Drive

Figure 7-33 Installing a PCI Card

Replacing a PCI Card

Step 1. Remove the cover. See "Removing and Replacing the Cover".
Step 2. Disconnect any cables that are connected to the PCI card.
Step 3. Release the PCI I/O riser by lifting the release handle. This action frees the PCI I/O riser from the system board.
Step 4. Grasp the edges of the PCI card being removed and gently rock the card releasing the connector from the PCI I/O
riser connector. Place the removed PCI card in an antistatic container.
Step 5. Grasp the edges of the replacement PCI card and gently press the connector into the PCI I/O riser connector.
NOTE
Step 6. Replace the PCI I/O riser assembly by positioning the connector over the mating connector on the system board
and then turning the jackscrew to complete the connector mating.
Step 7. Connect any cables that are required by the PCI card.
Step 8. Replace the cover. See "Removing and Replacing the Cover".
Removing and Replacing an Internal Hard Disk Drive
This section provides information about removing and replacing internal hard disk drives.
160
Full length PCI cards may only be installed in slot 1, the top slot of the PCI I/O riser assembly.
The lower slot (slot 2) can only accept half length cards.
Chapter 7