Replacing The Pci I/O Riser Assembly; Removing And Replacing Pci Cards; Removing A Pci Card - HP Integrity rx1600 Operation And Maintenance Manual

Replacing the PCI I/O Riser Assembly

Step 1. Remove the cover. See "Removing and Replacing the Cover".
Step 2. Disconnect any cables that are connected to any PCI card(s).
Step 3. Release the PCI I/O riser by lifting the release handle. This action frees the PCI I/O riser from the system board.
Step 4. Remove any PCI cards that are currently installed on the PCI I/O riser assembly. Place the removed PCI card in an
antistatic container.
Step 5. Install any PCI cards that were removed from the failed PCI I/O riser assembly into the replacement assembly.
Step 6. Replace the PCI I/O riser assembly by positioning the connector over the mating connector on the system board
and then turning the jackscrew to complete the connector mating.
Step 7. Connect any cables that are required by the PCI card.
Step 8. Replace the cover. See "Removing and Replacing the Cover".

Removing and Replacing PCI Cards

The server may contain up to 2 PCI cards. PCI cards are located on the PCI I/O riser assembly.
WARNING
Ensure that the system is powered-down and all power sources have been disconnected from the server
prior to removing or replacing a PCI card.
Voltages are present at various locations within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions could result in damage to the server.
Carefully read the following information concerning PCI slot configuration. Inserting a PCI card into a slot that is not
configured to accept it, may cause operation failure or the PCI card to operate at less than optimum speed. PCI slots are
numbered 1 and 2. See the labels on the rear panel of the chassis for correct PCI slot number identification.
The following describes configuration requirements for slots 1 through 2:
• Slot 1 (top) is a single, full size PCI slot that runs at 133MHz 64 bit.
• Slot 2 (bottom) is a single, half-size PCI slot that runs at 133Mhz 64 bit.

Removing a PCI Card

To remove a PCI card from the server, perform the following steps:
Chapter 7
Removing and Replacing Components
Removing and Replacing PCI Cards
157