Replacing A Pci/Pci-X Card Divider; Figure 4-27. Pci/Pci-X Card Divider - HP Integrity rx6600 User's & Service Manual

Removal and Replacement
Removing and Replacing PCI/PCI-X Card Dividers
Step 5. Pull the card divider up sharply by the handle to disengage it from the I/O board assembly
(Figure 4-27).
Figure 4-27 PCI/PCI-X Card Divider
Rear of
Chassis

Replacing a PCI/PCI-X Card Divider

To replace a PCI/PCI-X card divider, follow these steps:
Step 1. Insert the PCI/PCI-X card divider locking tabs into the slots on the I/O board assembly.
Step 2. Push down firmly to seat the card divider into the slots on the I/O board assembly.
Step 3. Replace the top cover. See "Replacing the Top Cover" on page 59.
Step 4. If rack installed, slide the server completely into the rack. See "Inserting the Server into the Rack"
on page 57.
Step 5. Reconnect the power cables and power on the server. See "Powering On the Server" on page 51.
124
Card Divider
Handle
Card Divider
Locking Tabs
Front of Chassis
Chapter 4