Controls, Ports and Indicators
Rear Panel
10/100 base-T ethernet LAN Connector
The rear panel 10/100 base-T ethernet LAN connector has the following status and activity LEDs.
Figure 2-7
10/100 base-T ethernet LAN Connector LEDs
Table 2-6
10/100 base-T ethernet LAN Connector LEDs
LED
Speed (yellow)
Activity (green)
Optional Management Processor Card LAN LEDs
The optional management processor LAN uses an RJ-45 type connector. This connector has four LEDs that signal status and
activity.
Figure 2-8
Optional Management Processor Card LAN LEDs
Table 2-7
Optional Management Processor Card LAN LEDs
LED
Self-test
10BT
100BT
22
Activity (Green)
1 2 3 4
Off—port linked at 10Mbps, On—port linked at 100Mbps
Off—no link established, On—port linked
Yellow—MP is running self-test or error detected
Green—10BT link established, blinking green—10BT link activity, off—no link
Green—100BT link established, blinking green—100BT link activity, off—no link
Speed (Yellow)
5 6 7 8
Description
Self-test
10BT
100BT
Standby power
Description
Chapter 2