Replacing The System Battery; Figure 7-24Removing The System Battery - HP Integrity rx1600 Operation And Maintenance Manual

Step 3. Lift up on the battery and push on the back of it with a flat-head screwdriver to remove the battery from its holder.

Figure 7-24Removing the System Battery

CAUTION
System Battery
Replacing the
Step 1. Perform system battery removal described above.
Step 2. Lift up on the battery holder retaining clip with a flat-head screwdriver and slide the battery into the holder. The
positive (+) terminal of the battery faces up.
CAUTION
Step 3. Replace the cover.
Step 4. Reconnect all of the power and external cables and turn on the system.
Step 5. You may need to reset the system time and date using the EFI time and date commands. Once you have set the
time, turn the system off, unplug the power cord, and wait for a minute before turning it back on. Execute the time
and date commands again. If the time and date are now correct, you have installed the battery correctly.
Chapter 7
Only lift the battery high enough to clear the holder. Excessive stress on the battery holder
retaining clip may damage the clip.
Only lift the battery high enough to clear the holder. Excessive stress on the battery holder
retaining clip may damage the clip.
Removing and Replacing Components
Removing and Replacing the System Battery
149