HP Integrity rx1600 Operation And Maintenance Manual page 113

Table 6-18 Processor Faults
System
LED 1
LED
Flashing Red
Red
Flashing Red
Red
Flashing Red
Red
Table 6-19 BMC Faults
System
LED 1
LED
Flashing Red
Red
Flashing Red
Red
Table 6-20 Temperature Faults
System
LED 1
LED
Flashing Red
Red
Table 6-21 Power Supply Errors
System
LED 1
LED
Flashing Red Off
Flashing Red Green
Chapter 6
LED 2 LED 3
Red Green Off
Red Off Green
Red Green Green
LED 2 LED 3
Green Red
Green Red
LED 2 LED 3
Green Green
LED 2 LED 3
Red Off
Red Off
Identifying and Diagnosing Hardware Problems
LED 4 Problem
Processor 0
temperature
exceeds limit
Processor 1
temperature
exceeds limit
No processor
detected.
LED 4 Problem
Off BMC
firmware is
damaged
Green System board
FRU inventory
device
inaccessible
LED 4 Problem
Red External air
temperature
too high
LED 4 Problem
Red VRM or power pod
fault
Red Power Supply fault
Troubleshooting
Solution
Make sure nothing is blocking the
system's airflow and locate your
system in an air-conditioned room. In a
single CPU configuration, verify that
the airflow blocker is installed.
Verify that the processor or processors
are correctly installed. See Chapter 4,
Installing and Configuring, for
installation procedures.
Solution
Turn off and unplug the system. Wait
20 seconds, then plug in and restart the
system. If the error repeats, replace the
base unit.
Replace the base unit.
Solution
Make sure nothing is blocking the
system's airflow and locate your
system in an air-conditioned room.
Solution
View the SEL for additional
information.
View the SEL for additional
information. Replace the power
supply if necessary.
115