Step
4. Place the processor and heatsink assembly over the processor socket. Use the four locator posts on the assembly to
align with the locator holes on the system board.
Figure 7-17Aligning the Processor Assembly
Step
5. Use the special processor tool shipped with your replacement processor assembly to lock the processor in place on
the system board. To do this, insert the special processor tool into the hole that runs down the side of the heatsink
and rotate it clockwise 180 degrees.
Figure 7-18Locking the Processor Assembly in Place
Unlocked
Chapter 7
Locked
Removing and Replacing Components
Removing and Replacing a Processor
Front of server
Front of server
145