Extend The Server From The Rack; Insert The Server Into The Rack - HP Integrity rx1600 Operation And Maintenance Manual

Removing and Replacing Components
Accessing a Rack Mounted Server
WARNING
Ensure that all anti-tip features (front and rear anti-tip feet installed with adequate ballast properly
placed) are employed prior to extending the server.

Extend the Server from the Rack

NOTE
Ensure that there is enough area (Approximately 1.5 meters [4.5 ft.] to fully extend the server out the front and
work on it.
To extend the server from the rack, perform the following steps:
Step 1. Remove the T-25 screws that fasten the server to the rack.
Step 2. Slowly pull the unit forward. The server is fully extended when the rail clips are locked in place. When fully
extended, the top cover is fully accessible.

Insert the Server into the Rack

To insert the server into the rack, perform the following step:
Step 1. Press the rail clips on either side of the server inward and push the server into the rack until it stops.
Step 2. Replace the T-25 screws that fasten the server to the rack.
132
Chapter 7