Accessing The Fuse - Fluke 5700A Series II Operator's Manual

2-7. Accessing the Fuse

To prevent instrument damage, verify that the correct fuse is
installed for the line voltage setting.
The line power fuse is accessible on the rear panel. The fuse rating label to the right of
the fuse holder (labeled F1) shows the correct replacement fuse rating for each line
voltage setting. To check or replace the fuse, refer to Figure 2-1 and proceed as follows:
1. Disconnect line power.
2. Using a standard screwdriver, loosen the fuse holder by turning the slot labeled F1
until the cap and fuse pop free.
3. Replace the fuse and holder.
CHASSIS
GROUND
S2 S3 S4
Caution
VOLTAGE VOLTAGE
FUSE-F1 FUSE-F1
SELECTION SELECTION
S2 S3 S4 S2 S3 S4
100V 200V
T 3A
110V 220V
250V
115V 230V
(SB)
120V 240V
!
FUSE -F1
Figure 2-1. Accessing the Fuse
T 1.5A
250V
(SB)
Installation 2

Accessing the Fuse

2-5