Power Source - Fluke 5700A Series II Operator's Manual

Symbols Marked on Equipment
S
DANGER — High Voltage
Q
Protective ground (earth) terminal
P
Attention — refer to the manual. This symbol indicates that information about
the usage of a feature is contained in the manua

Power Source

The 5700A Series II and 5720A Series II are intended to operate from a power source that
will not apply more than 264V ac rms between the supply conductors or between either
supply conductor and ground. A protective ground connection by way of the grounding
conductor in the power cord is essential for safe operation.
Use the Proper Fuse
To avoid fire hazard, use only the fuse specified on the line voltage selection switch label,
and which is identical in type voltage rating, and current rating.
Grounding the 5700A Series II or 5720A Series II
The 5700A Series II and 5720A Series II are Safety Class I (grounded enclosure)
instruments as defined in IEC 348. The enclosure is grounded through the grounding
conductor of the power cord. To avoid electrical shock, plug the power cord into a
properly wired earth grounded receptacle before connecting anything to any of the 5700A
Series II or 5720A Series II terminals. A protective ground connection by way of the
grounding conductor in the power cord is essential for safe operation.
Use the Proper Power Cord
Always use the power (line) cord and connector appropriate for the voltage and outlet of
the country or location in which you are working.
Always match the line cord to the instrument.
•
Use the AC line cord supplied with this instrument with this instrument only.
•
Do not use this line cord with any other instruments.
•
Do not use any other line cords with this instrument.
Use only the power cord and connector appropriate for proper operation of a 5700A Series
II or 5720A Series II in your country.
Use only a power cord that is in good condition.
For detailed information on power cords, refer to Figure 2-3 in Chapter 2.
Refer cord and connector changes to qualified service personnel.
Do Not Operate in Explosive Atmospheres
To avoid explosion, do not operate the 5700A Series II or 5720A Series II in an
atmosphere of explosive gas.
Do Not Remove Cover
To avoid personal injury, do not remove the cover from the 5700A Series II or 5720A
Series II. Do not operate the 5700A Series II or 5720A Series II without the cover properly
installed. There are no user-serviceable parts inside the 5700A Series II or the 5720A
Series II, so there is no need for the operator to ever remove the cover.
l.