Fluke 5700A Series II Operator's Manual page 170

5700A/5720A Series II
Operators Manual
CAL_INTV
Description
Parameter
CAL_INTV?
Description
Parameter
Response
CAL_PR
Description
Parameter
CAL_REF
Description
Parameter
Example:
5-20
Table 5-2. Commands (continued)
Sequential command, ignored if not in remote.
Sets the calibration interval for main output calibration. This value is saved in nonvolatile
memory and used for calculating the calibrator's output uncertainty.
1, 90, 180, or 365; the number of days in the calibration cycle.
Sequential command.
Returns the calibration interval for main output calibration.
None
(Integer) 1, 90, 180, or 365; the number of days in the calibration cycle.
Overlapped command.
Sends a calibration report printout for a particular calibration activity through the RS-232-C
serial interface. This is for IEEE-488 remote control only. (See Chapter 6 for printout format
details.)
CAL (Output change report for calibration)
CHECK (Output change report for cal check)
RAW (A list of all calibration constants)
Overlapped long-term command, ignored if not in remote.
Calibrates the internal references for the main output functions based on comparison to an
externally-applied standard. To calibrate the 5700A/5720A Series II calibrator, the controller
must send a CAL_TEMP command, a sequence of CAL_REF commands (one for each
external standard), followed by a CAL_ADJ command, then a CAL_STORE command.
These commands must be in the same sequence as in the example. Note that the
CALIBRATION switch must be set to ENABLE for the CAL_STORE command. To only
collect performance data, use this command without a CAL_STORE.
The true value of the external standard attached to the calibrator's binding posts. The value
and units of the parameter tell the calibrator which calibration procedure to perform.
CAL_TEMP 23.5
CAL_REF 10.00013 V ; *WAI
CAL_REF -10.00013 V ; *WAI
CAL_REF 9.99987 KOHM ; *WAI
CAL_REF 1.00026 OHM ; WAI
CAL_ADJ
CAL_STORE ;
*WAI