Fabric Parameters; Bb_Credit; R_A_Tov; Configure Fabric Parameters Dialog Box - HP Surestore 64 - Director Switch Installation Manual

Installing and Configuring the Director 2/64
Figure 42: Configure Fabric Parameters dialog box
3. Use information under
4. After you change settings, click the Activate button.
5. Back up the configuration data when you are finished configuring the switch.
6. Set the director online. For instructions, see

Fabric Parameters

Configure the following parameters as required by your fabric.

BB_Credit

Configure the director to support buffer-to-buffer credit (BB_Credit) from 1
through 60. This is the value used for all ports, except those configured for
extended distance buffering (10-100 km). The default value is 16. For a
description of the buffer-to-buffer credit, refer to the industry specification, Fibre
Channel Physical and Signaling Interface.

R_A_TOV

Configure resource allocation time-out value (R_A_TOV) in tenth-of-a-second
increments. This variable works with the error detect time-out value (E_D_TOV)
variable to control the director's behavior when an error condition occurs.
Resources are allocated to a circuit when errors are detected and are not released
for reuse until the time set by the R_A_TOV value expires. The default value is
100 tenths (10 seconds). Set a value between 10 tenths and 1200 tenths (1 through
120 seconds).
94
parameters in this dialog box.
page 87.
"Fabric Parameters" to change settings as required for
"Set the Director Online" on
Director 2/64 Installation Guide