Switch Parameters; Domain Id; Configure Switch Parameters Dialog Box - HP Surestore 64 - Director Switch Installation Manual

Installing and Configuring the Director 2/64
2. Choose Configure > Operating Parameters > Switch Parameters. The
Figure 41: Configure Switch Parameters dialog box
Ordinarily, you do not need to change values in this dialog box from their
defaults. The only exception is the Preferred Domain ID. Change this value if
the director will participate in a multi-switch fabric.
1. Use information under
2. After you change settings, click the Activate button.
3. Set the director online. For instructions, see

Switch Parameters

Configure the following parameters as required by your fabric.

Domain ID

The domain identification is a value between 1 and 31 that provides a unique
identification for the director in a fabric. A fabric director cannot contain the same
domain ID as another director or their E_Ports will segment when they try to join.
In the Configure Switch Parameters dialog box, a field is provided to enter a
preferred domain ID and a check box is provided to enable this ID as an insistent
domain ID.
90
Caution: Setting the director offline terminates all Fibre Channel connections.
Configure Switch Parameters dialog box displays, as shown in
parameters in this dialog box.
page 87.
"Switch Parameters" to change settings as required for
"Set the Director Online" on
Director 2/64 Installation Guide
Figure 41.