Hyperterminal Dialog Box - HP Surestore 64 - Director Switch Installation Manual

Installing and Configuring the Director 2/64
Figure 34: HyperTerminal dialog box
11. To change director network addresses, type the following at the C> prompt
12. Choose Exit from the File drop-down menu.
13. Click Yes.
14. Click No to exit and close the HyperTerminal application.
15. Power off the maintenance terminal:
16. Disconnect the RS-232 null modem cable from the director and the
78
and press Enter.
ipconfig xxx.xxx.xxx.xxx.yyy.yyy.yyy.yyy.zzz.zzz.zzz.zzz
The IP address format is xxx.xxx.xxx.xxx. The subnet mask format is
yyy.yyy.yyy.yyy. The gateway address format is zzz.zzz.zzz.zzz. The octets
xxx, yyy, and zzz are decimals from 0 through 255. If a network address is to
remain unchanged, type the current address in the respective field.
When the new network addresses are configured at the director, the message
Request completed OK displays at the bottom of the HyperTerminal
window.
a. Choose Start > Shut Down. The Shut Down Windows dialog box
displays.
b. Choose Shut down and click Ok to power off the PC.
maintenance terminal. Replace the protective cap over the maintenance port.
Director 2/64 Installation Guide