Hp System/E And Industry-Standard 19-In Rack Installation; Install The Anti-Tip Feet On A Hp System/E Rack; Aligning The Switch In The Rack - HP Surestore 64 - Director Switch Installation Manual

9. Connect the equipment rack power cords to separate (for redundancy) facility
Figure 14: AC power connections

HP System/e and Industry-Standard 19-in Rack Installation

To install the director in a HP system/e or industry-standard 19-in rack, complete
the procedures in the following sections:

Install the Anti-tip Feet on a HP System/e Rack

Use the following procedure to mount anti-tip feet on a HP system/e rack only, as
shown in
1. Place the anti-tip feet (1), provided in the HP system/e and industry-standard
2. Secure the anti-tip feet (1) to the base of the rack (front and rear).
Director 2/64 Installation Guide
power sources, providing single-phase, 120 to 240 VAC current.
Install the Anti-tip Feet on a HP System/e
Install Mounting Bracket Hardware in the
Prepare the Front and Rear Rack
Prepare the Switch for
Finalize the Rack Mounting
Sliding Shelf Installation—For an HAFM Server
Recommended Cable
Figure 15:
19-in rack mount kits on the front and rear of the rack base.
Installing and Configuring the Director 2/64
Rack, page 58
Columns, page 62
Installation, page 63
Procedure, page 65
Management, page 70
Rack, page 57
only, page 67
57